Anybody else using these? Perhaps I’ve adjusted the settings poorly?
Might be! Have you considered ‘clipping’?
If you have too many effects going on at once you get clipping; its when the motor is driven at max output and no difference between effects can be made anymore.
For this reason I always leave the engine rumble and turbulence off.
Also increasing the gain on the G force setting helps.
This way the seat only responds when you fly your aircraft on the edge of the envelope or when you make aircraft configuration changes (speed brake, flaps, gear).
Also keep in mind that setting an effect slider on max will make the motor run at max rumble not leaving any room for added effects.
So think about which effects often need to be put through at the same time and balance their sliders to have the more important one give a slightly higher output.
It takes a bit of trial and error, but I am certainly one of the people who won’t fly without JetPad anymore, especially in VR!
Another great application is Racing games!
