GrogHeads Forum

Tabletop Gaming, Models, and Minis => Modelling and Miniatures => Topic started by: acctingman on May 29, 2020, 09:23:35 AM

Title: Anyone here own/use a 3d resin printer?
Post by: acctingman on May 29, 2020, 09:23:35 AM
Curious to know if anyone here owns one? If so, what make? How has your experience been using it? How bad are the fumes and post processing?

Title: Re: Anyone here own/use a 3d resin printer?
Post by: amichaell on October 27, 2020, 10:07:00 AM
I saw this is an older topic, though since no one replied, I'll give my two cents.

I own an Elegoo Mars resin. I have zero problems with fumes using Hero resin. The post processing is a bit of a chore, though not bad once you get it down. I tend to print a lot in 6 mm, so removing supports can be a headache, though otherwise it isn't a big deal at all. Overall, I'm extremely happy with my resin and Mars experience.
Title: Re: Anyone here own/use a 3d resin printer?
Post by: Jarhead0331 on October 27, 2020, 11:04:00 AM
I have a Prusa i3 MK3S, but this isn't resin.

See here: http://www.grogheads.com/forums/index.php?topic=22750.0 (http://www.grogheads.com/forums/index.php?topic=22750.0)