Building a DIY Apache TEDAC

[Jarhead0331]

I've been frustrated trying to map TEDAC (TADS Electronic Display and Control) controls to my existing flight peripherals so I decided to try to build my own based on some open-source work created by other very talented individuals. Other than the 3D printing parts, this is very far outside of my skill set so it is going to take a long time, but I will try to do my best.

So far, I am working on printing the left and right grips.





If all goes according to plan, eventually it will look like this...and work with DCS too!

[Con]

Where does the mount for the my pretty unicorn air to air ping pong missiles go?

[Gusington]

Good luck JH, that looks...complex...to say the least.