I've been frustrated trying to map TEDAC (TADS Electronic Display and Control) controls to my existing flight peripherals so I decided to try to build my own based on some open-source work created by other very talented individuals. Other than the 3D printing parts, this is very far outside of my skill set so it is going to take a long time, but I will try to do my best.
So far, I am working on printing the left and right grips.
(https://scontent-lga3-2.xx.fbcdn.net/v/t39.30808-6/451011138_10160881599772702_3498364474107227615_n.jpg?stp=cp6_dst-jpg&_nc_cat=101&ccb=1-7&_nc_sid=aa7b47&_nc_ohc=fJ8RJ2-ZXqgQ7kNvgFzC3tA&_nc_ht=scontent-lga3-2.xx&oh=00_AYCM-rnIthLdpFr5sConvGnZl0EkopC55JwCwyNr1FD4cg&oe=6698B2AA)
(https://scontent-lga3-1.xx.fbcdn.net/v/t39.30808-6/450916342_10160881599857702_5806608326401053815_n.jpg?stp=cp6_dst-jpg&_nc_cat=110&ccb=1-7&_nc_sid=aa7b47&_nc_ohc=1x-ZoGcfLMIQ7kNvgG7AC7I&_nc_ht=scontent-lga3-1.xx&oh=00_AYBHiHeqk6B8Un5ZR4NghYkLnfNpS23T0Ft4kzMRRH-4jg&oe=6698935E)
If all goes according to plan, eventually it will look like this...and work with DCS too!
(https://static.wixstatic.com/media/442d33_f8d0a599c3254d22bc2e57aabc38bf4e~mv2.jpg/v1/fill/w_900,h_678,al_c,q_85,usm_0.66_1.00_0.01,enc_auto/IMG_20231023_212029.jpg"%5Dhttps://static.wixstatic.com/media/442d33_f8d0a599c3254d22bc2e57aabc38bf4e~mv2.jpg/v1/fill/w_900,h_678,al_c,q_85,usm_0.66_1.00_0.01,enc_auto/IMG_20231023_212029.jpg)
Where does the mount for the my pretty unicorn air to air ping pong missiles go?
Good luck JH, that looks...complex...to say the least.